Mini Enail G9 V2

Features:

• Temperature range: 0 → 649 ℃ (0 → 1200 ℉)
• Voltage: 85 - 260V / 50 - 60 Hz
• Manufacturer's warranty: 1 year

Kit contents:

• 1 x G9 Mini eNail with USB port
• 1 x Kevlar Heat Coil Ø 25 mm
• 1 x heavy duty power cable
• 1 x quartz banger ♂ Ø 14 mm
• 1 x directional quartz carb cap
• 1 x user manual (in English, transcribed below)

Use:

1. If you haven't already done so, get a water filter with a Ø 14mm female ♀ joint. Fill it with a little water.
2. Fit the coil on the banger supplied, making sure it fits properly. If it's too tight, disassemble it and adjust as much as necessary.
3. Plug the G9 PID controller into a power outlet, connect the coil and switch on the PID controller using the green switch on the back of the controller.
4. Set the desired temperature using the up  ˄  and down  ˅  keys (0 → 1200 ℉ or 0 → 649 ℃). Once selected, it should flash about ten times.
5. Drop your concentrate into the banger and start inhaling gently, covering it with the carb cap provided. Enjoy!

⚠️ As the coil and banger can become extremely hot during use, please do not touch them until they have cooled down completely!
Do not leave the unit unattended and keep it out of the reach of children and pets.