Sublimator Vaporizer

The kit includes:

The vaporizer Sublimator differs from other vaporizers in that it uses a vaporization process.

Indeed, the plants are heated by hot air, which gasifies the active ingredients. Classic principle until then.

It is just after that the principle of atomization takes place, the steam passes through an atomizer that heats it and multiplies its volume by dividing the droplets of steam.

This way, you get bigger lattes with the same dose and, above all, you get more active ingredients in one inhalation because the vapour droplets are finer.

This vaporizer is for expert vaporists and lovers of strong or very strong sensations.

If you like soft lattes and long lasting sessions this vapo is not for you.

An extraction of the active ingredients and a respect of the flavours unequalled in the world of vaporizers.

This vaporizer is perfect for a complete and fast extraction of the active ingredients.

A vaporizer of choice for medical users in herbal medicine who need fast and effective relief.

The sublimator is available in 3 different models:

The Sublimator Original Kit = For dry plants / resins

The Sublimator Nail Kit = For butane extraction type concentrates.

The Sublimator Dabmaster Kit = For dry plants/resins AND for butane extraction type concentrates, concentrated.

The one we strongly recommend because for a difference of a few euros you are 100% equipped and can vaporizer any type of product.

"After vaporization, sublimation!"

Or rather atomization as described above.

In fact, sublimation can be described as the passage from a solid to a gaseous state without leaving any solid residue. Out with the vaporizer SublimatorYou will get back some solid matter, BUT all the active ingredients will have been sublimated (as with any good vaporizer).

The originality of the Sublimator is in its ability to extract all the active ingredients in a single lath and in the atomization of the steam allowing a better absorption of the active ingredients.

This also allows for a super successful rendering of flavors because the flavonoids are not damaged little by little as with most vaporizers, but in one go.

Finally, the sublimator vaporizer extracts the aromas and active ingredients of aromatherapy plants and medicinal herbs with the power of a Bang.

On this vaporizer, the temperature control is done via a box that offers 12 levels of temperature and ensures 0 combustion

The sublimator comes with a tube that allows you to add water if you wish.

Beware, as the Sublimator is not adaptable to any Bang.

Some safety instructions before use:

You must be very careful not to burn yourself with the heating element and of course not to leave it within the reach of children!

The heating time of the sublimator is about 10 minutes.

INSTRUCTIONS FOR USE OF THE SUBLIMATOR SPRAYER

IMPORTANT:

The heat source in the Sublimator is extremely hot.

Improper use may result in fire and/or serious injury. Do not allow any material to fall into the Sublimator. Unplug the cord before cleaning to avoid electrical shock.

Do not expose the Sublimator to moisture. If the Sublimator comes into contact with water, is damaged or emits smoke, unplug the Sublimator and stop using it.

Failure to follow or modify the instructions will void all warranties. Under no circumstances will the company Sublimator is responsible for injury or loss of property during the use or misuse of this product. This product is intended for aromatherapy and therapeutic purposes only.

Consult your health care professional for advice.

We've found these tips useful for getting started with your new Sublimator:

Crush your flowers to a medium/fine consistency, a grinder is recommended. (Grinder)

• Clean the lower section of the cone-shaped container (the bowl) and the atomizer with ISO (Isopropyl Alcohol) to remove all possible residues from your new Sublimator.

• Place the rack on the top narrower part of the bowl at the top of the cone.

Place the Dabmaster heat injector on top of the cone, assemble the two parts in one piece on the base of the cone and place the heat injector on top SublimatorIf you are using the Dabmaster in a small bubbler, leave a minimum of 10 cm margin to support the Dabmaster and the atomizer safely. Do not use in a small bubbler, it is unstable!

• You must operate your Sublimator when the green light on your controller comes on.
• With a Sublimator When the atomizer is cold, wait 10-15 minutes for it to warm up to the desired temperature and reach thermal equilibrium. The heat injector and the cone/atomizer bowl should reach the same temperature by heat conduction.
• Once heat balance is reached, use the top handle to lift the heat injector and place 0.1 grams-0.15 grams of dried herbs into the top of the bowl and give it a quick stir with a heat-safe tool to stir your herbs without them settling.
• Put the Apollo heat injector back on the top of the cone. Using water in your pipe is optional, try using it dry first.
• Take a long strong/fast inhale by lifting the lower handle attached to the cone/atomizer, until your lungs are almost able to suck all the vapor out of the pipe.
• Wait 30 seconds between each inhalation to see if you need another one, always stir your herbs between each inhalation.
• Always empty the used bowl while it is still very hot, a cold bowl is always more difficult to clean. Remember to close the Sublimator when finished, you can turn the power control knob until you hear a click or press the regulator button to turn off the Apollo heat injector. Always unplug the Apollo when not in use.
• The Sublimator is a medical device, the metal parts become extremely hot and can cause severe burns if touched, dropped or brought into contact with flammable materials. Use the Sublimator with care and common sense. Remember to always turn off and unplug the Sublimator after use.

We found these tips useful for getting started with Le Sublimator for Concentrates, this one then works as E-Nail

Thoroughly clean the bottom section of the cone-shaped container and the vaporizer with ISO (Isopropyl Alcohol) to remove all residues from your new E-Nail.

• Place the rack on the top narrower part of the bowl at the top of the cone.
• Place the heat injector of the E.Nail on top of the cone, assemble the two parts in one piece on the base of the Sublimator.
• You must operate your Sublimator when the green light on your controller comes on.
• With a cold E-Nail, wait 10-12 minutes for it to warm up to the desired temperature and reach thermal equilibrium. The E-Nail and the cone/atomizer bowl should reach the same temperature by heat conduction.
• Once it has reached thermal equilibrium, use the top handle to lift the E-Nail and put the pure concentrate into the top slot of the E-Nail.
• Put the E-Nail heat injector back on the top of the bowl if you removed it and assemble the two parts into one piece. Using water in your pipe is optional, try using it dry first.
• Take a long strong/quick inhale by lifting the heating element connected to the cone/atomizer, until your lungs are almost able to suck all the vapor out of the pipe.
• Wait 30 seconds between each inhalation to see if you need another one, always stir your herbs between each inhalation.
• Always empty the used bowl while it is still very hot, a cold bowl is always more difficult to clean. Remember to turn off the E-Nail when you finish, you can turn the power control knob until you hear a click or press the timer button to turn off the E-Nail. Always unplug the E-Nail when not in use.
• The E-Nail is a medical device, the metal parts become extremely hot and can cause severe burns if touched, dropped or brought into contact with flammable materials. Use the E-Nail with caution and common sense. Always remember to turn off and unplug the E-Nail after use.

*** Never put a dabmaster or E-Nail on a hot atomizer as the two parts may melt together. ***

For any questions before or after purchasing this product, our team of enthusiasts is at your disposal on our Steam Hotline at 01.83.64.69.26 from 10am to 6pm from Monday to Friday.

You can also order directly over the phone if you wish.

If you want to buy a vaporizer in Paris, our shop is 3 minutes away from the Voltaire metro station on line 9, at 6 boulevard Magenta 75010 Paris.

⚠️ Glass is not covered by warranty, so we advise you to shake your package before signing for its reception and to sign with reservation if in doubt. In case of broken glass upon receipt, you have one hour to report it to us, otherwise no request can be accepted.

☎️ For any questions before or after purchase, our team of enthusiasts is at your disposal on our vape hotline at +33 1 83 64 69 26 from 11 am to 7:30 pm from Monday to Friday, and from 12:30 pm to 7:30 pm on Saturday. You can also place an order directly over the phone if you wish.

If you want to buy a vaporizer in Paris, our vaporizer shop is 500 meters from the République metro station, at 16 boulevard de Magenta, 75010 Paris.