Heater cup for Divine Crossing V5

Installation:

Under the right settings these cups should last a long time, when a v5 replacement heater cup goes out or the resistance rises you can replace it by unscrewing 2 of the screws that keep the cup’s lead wires fastened to the deck. Loosen screws then gently pull the cup out and remove.  

Every now and then you will want to burn off residue on the cup. Set the mod to 38w in wattage mode (this can be less for some mods, always start low and see) hold upside down while delivering only two minutes of heat to the cup. STOP allow it to completely cool off before next cleaning session. 

Please see the Divine Tribe Youtube Channel for videos with instructions on how to use, clean, and rebuild the unit.